Hello,
you need to build SANE from source. See if your distribution has a
source RPM for SANE or see http://www.mostang.com/sane to pick up the
sources.
--Peter
> herwig verbeke wrote:
>
> I have a HP ScanJet IIcx and installed sane-1.0.4-2mdk.i586.rpm and
> sane-backends-1.0.4-2mdk.i586.rpm on mandrake 8.0.
>
> # scanimage -L gives:
>
> device 'hp:/dev/sga' is a Hewlett-Packard C2500A flatbed scanner
>
> # find-scanner gives:
>
> find-scanner: found processor "HP C2500A 3332" at device /dev/sg0
> find-scanner: found processor "HP C2500A 3332" at device /dev/sga
>
> When I run:
>
> # scanimage -d hp:/dev/sga
>
> the program takes control of the scanner and starts to scan but
> immediately stops with the message:
>
> scanimage: sane_read: Error during device I/O
>
> If I then run scanimage -L or find-scanner, the scanner is not found
> anymore. After rebooting the scanner is found again.
>
> Note; In an earlier posting to this mailing list Abel Deuring
> suggested modifying sanei/sanei_scsi.c. I am unable to locate this
> file. Where can I find it on Mandrake 8.0
-- Peter Kirchgessner http://www.kirchgessner.net mailto:peter@kirchgessner.net-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
This archive was generated by hypermail 2b29 : Sat Apr 21 2001 - 03:45:32 PDT