Mustek ScanExpress 12000P. Is it SCSI?

aRtsCi - Nikolas Diamandis (artsci@freemail.gr)
Sun, 13 Dec 1998 14:34:13 +0200

Messages sorted by: [ date ][ thread ][ subject ][ author ]
Next message: Hugo van der Kooij: "Re: Mustek ScanExpress 12000P. Is it SCSI?"
Previous message: Justin Young: "RE: future supported devices"
Next in thread: Dr. Andreas Bolsch: "Re: Mustek ScanExpress 12000P. Is it SCSI?"
Reply: Dr. Andreas Bolsch: "Re: Mustek ScanExpress 12000P. Is it SCSI?"
Reply: aRtsCi - Nikolas Diamandis: "Re: Mustek ScanExpress 12000P. Is it SCSI?"

I can't figure out which kind of interface this scanner uses!!!
Should I treat it as a SCSI device or as a PARALLEL port scanner?
Actually I know that I connect it at the parallel port without any
other inside the computer cards and in parallel to the printer.
I'm a bit confused. Plz help 'cause in man sane-mustek I see that
12000SP is SCSI, so I suspect that mine is SCSI too.
Should I compile the kernel with SCSI support (I don't have any other
devices that need SCSI support) and if so, what are the exact options I
should enable?

Thanx in advance.

-- Nikolas Diamandis mailto:artsci@freemail.gr

--
Source code, list archive, and docs: http://www.mostang.com/sane/
To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com

Next message: Hugo van der Kooij: "Re: Mustek ScanExpress 12000P. Is it SCSI?"
Previous message: Justin Young: "RE: future supported devices"
Next in thread: Dr. Andreas Bolsch: "Re: Mustek ScanExpress 12000P. Is it SCSI?"
Reply: Dr. Andreas Bolsch: "Re: Mustek ScanExpress 12000P. Is it SCSI?"
Reply: aRtsCi - Nikolas Diamandis: "Re: Mustek ScanExpress 12000P. Is it SCSI?"