Re: core dump using umax driver on sparc solaris

From: Oliver Rauch (oliver.rauch@rauch-domain.de)
Date: Tue Mar 06 2001 - 07:51:39 PST

  • Next message: Jody Williams: "Re: Problems with HP Scanjet 4c"

    Ron Shonkwiler wrote:
    >
    > Trying to use sane to drive a umax powerlook III on a sparc solaris8
    > system. I have installed Schily's scg scsi drivers (and use them
    > with cdrecord on my system). Compiled the backend only, set the
    > umax.conf to
    >
    > option scsi-maxqueue 2
    > scsi UMAX * Scanner
    > /dev/scg0g
    >
    > tested with scanimage -L and see the device, there is a line such as
    > device 'umax:/dev/scg0g' ...
    >
    > but all attempts to scan result in a core dump. I have carefully
    > checked scsi termination and can rule that out as a cause.
    >
    > By contrast, going through the same motion on my linux laptop
    > results in a successful scan.
    >

    Hi Ron,

    did you test sane-umax-1.0 build 25?
    It is available on my homepage, you should copy this version
    over sane-1.0.4 .

    To find out where the error occurs you should set the
    environment variable SANE_DEBUG_UMAX to 12

    Bye
    Oliver 

    -- 
Homepage:	http://www.rauch-domain.de
sane-umax:	http://www.rauch-domain.de/sane-umax
xsane:		http://www.xsane.org
E-Mail:		mailto:Oliver.Rauch@rauch-domain.de

    --
Source code, list archive, and docs: http://www.mostang.com/sane/
To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com

    This archive was generated by hypermail 2b29 : Tue Mar 06 2001 - 07:41:39 PST