On Montag, 20. November 2000 18:03, you wrote:
> Hi,
>
> I've got Mandrake 7.1 installed with a Adaptec 2940 SCSI card. For some
> reason, i am having a problem scanning in color mode. Lineart works fine,
> but high resolution gray scale or color completely locks up. It will load
> the page in the document feeder and just stop. Scanimage starts to print
> the header where is shows 'SANE DATA FOLLOWS' but nothing follows. After
> about 5 minutes of sitting there, i start to get SCSI errors and it tries
> to reset the bus. 'No SCB' errors and others. Again, like i said Lineart
> works fine. I've tried various settings to the controller card and that had
> no affect. I also tried to increase the buffer size with the sane
> environmental variable with no results. I had this identical problem with a
> totally different computer and the SCSI card shipped with the scanner. Does
> anyone have any suggestions?
Hey, what scanner do you have? And what scsi card is built in the other
computer you also tested?
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
This archive was generated by hypermail 2b29 : Mon Nov 20 2000 - 10:14:23 PST