Peter Kirchgessner wrote:
> Hi Keith,
>
> try SANEs find-scanner tool to find out the correct device. Maybe you
> need to link to /dev/sg0.
>
> --Peter
>
> Keith Gross wrote:
> >
> > Hi,
> >
> > I'm trying to use sane with a SCSI HP 5p scanner. The problem, the
> > device does not show up as a usable device:
> > # scanimage -L
> > device `pnm:0' is a Noname PNM file reader virtual device
> > device `pnm:1' is a Noname PNM file reader virtual device
> >
> > Linux (COL 2.2) see's the scanner as shown in the following dmesg:
> > Vendor: HP Model: C5110A Rev: 3635
> > Type: Processor ANSI SCSI revision: 02
> > Detected scsi generic sgb at scsi0, channel 0, id 2, lun 0
> >
> > The hp.conf file contains the following:
> > scsi HP
> > /dev/scanner
> >
> > The /dev/scanner is a sym link to /dev/sgb (sgb links to sg1) and
> > permissions are set to 666.
> >
> > Any help on this matter is greatly appreciated.
> >
> > --
> > Source code, list archive, and docs: http://www.mostang.com/sane/
> > To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
>
> --
> Peter Kirchgessner
> WWW: http://www.kirchgessner.net
> e-mail: peter@kirchgessner.net
>
> --
> Source code, list archive, and docs: http://www.mostang.com/sane/
> To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com