Stepping through the Microtek code with gdb, I found that "start_scan()"
returns OK. But the "ready" light on the scanner goes out at that
point, and the following call, to "wait_ready()", then fails. The same
"start scan" commands ("0x1b, 0, 0, 0, 0x41" for grayscale) are being
passed in both operating systems, so I'm at a loss as to what's going
on.
Any suggestions as to why the "ready" light would stay off, and where I
might look next?
Thanks!
-- Jeff
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com