Hi Sönke,
two Ideas:
1) There was a timeout problem in the SCSI-routines of SANE-1.0.4. See
the following:
| This is part of an article from Abel Deuring from this list:
|
| The SG driver changed. But the guilty one is me; I used a too short
| timeout value for the new SG driver. In sanei/sanei_scsi.c, look for a
| line like
|
| req->sgdata.sg3.hdr.timeout = 10000;
|
| (line 1892 for Sane 1.0.4), and change it to
|
| req->sgdata.sg3.hdr.timeout = 1000 * 10 * 60;
or upgrade to SANE-1.0.5.
2) Try the microtek2 backend in case your scanner uses the SCSI-2
command set.
If this doesn't help you should create a logfile so that one can see on
which SCSI-command the error occurs. (At least in the new
microtek2-manpage is a description how to do that).
Greetings
Karsten
Sönke Ruempler wrote:
>
> Hi,
>
> I have a scanner called Highscan MRS-600E3. its attached to a adaptec
> ava1502 scsi controller.
>
> the controller works fine with the aha152x module and the scanner is
> recognized as sg0.
>
> here is a scanimage -L:
> device `microtek:/dev/scanner' is a Microtek ScanMaker E3 flatbed
> scanner
>
> but if i do a scanimage -T, the folloing appears:
> scanimage: sane_start: Device busy
>
> /var/log/messages says:
> Jul 3 18:27:02 blah kernel: (scsi0:6:0) cannot abort running or
> disconnected co
> mmand
> Jul 3 18:27:02 blah kernel: (scsi0:6:0) cannot reset current device
> Jul 3 18:27:02 blah kernel: aha152x0: scsi reset in
> Jul 3 18:27:08 blah kernel: scsi: device set offline - not ready or
> command ret
> ry failed after bus reset: host 0 channel 0 id 6 lun 0
>
> The ready lamp at the scanner is off.
>
> I hope someone can help me :|
> --
>
> Mit freundlichem Gruß
> Sönke Ruempler
>
> top concepts Internetmarketing GmbH
> ------------------------------------------------------
> http://www.topconcepts.com Tel. +49 4141 9912 30
> mail: ruempler@topconcepts.com Fax. +49 4141 9912 33
> ------------------------------------------------------
> 24h-Support Hotline: +49 1908 34697 (? 1.86/Min,CNS24)
> ------------------------------------------------------
>
> --
> Source code, list archive, and docs: http://www.mostang.com/sane/
> To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
This archive was generated by hypermail 2b29 : Thu Jul 05 2001 - 12:09:29 PDT