I don't know why, but in debug mode saned work correctly, and even scanned up to the same point scanimage did (the first pass and then aborted)
The output of saned after the first pass is this:
[microtek] sane_read...
[microtek] pack_into_dest...
[microtek] pack_into_dest: rl: 2034 sz: 32300 hc: 24316
[microtek] sane_read...
[microtek] end_scan...
[microtek] .stop_scan...
SPS:1b 0 0 0 0 0
[microtek] end_scan: OY! on stop_scan
[microtek] sane_start...
[microtek] sane_get_parameters...
[microtek] sane_get_parameters: regular 3-pass color
[microtek] sane_get_parameters: res_code = 33 (21)
[microtek] sane_get_parameters: dots_per_mm: 3.937008
[microtek] sane_get_parameters: units_per_mm: 11.811024
[microtek] WIDTHPIX: before exp: 850
[microtek] sane_get_parameters: lines: 1400 ppl: 850 bpl: 850
[microtek] set_pass_parameters: three-pass, on 2
[microtek] sane_start: open of /dev/ss0 failed: Invalid argument
[microtek] end_scan...
[microtek] sane_cancel...
[microtek] end_scan...
[microtek] sane_close...
[microtek] sane_exit...
[microtek] sane_exit: MICROTEK says goodbye.
Can someone tell me what's wrong with my scanner/my sane?
It worked fine under Linux with my PC, same cable, same terminator...
Again, my compute is a SPARStation IPC from sun and I?m using the built in SCSI adapter.
Thanks
Aristide Aragon
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
This archive was generated by hypermail 2b29 : Mon May 28 2001 - 15:19:20 PDT