No scanners identified

From: Daniel Karlsson (danka@home.se)
Date: Wed Feb 28 2001 - 13:41:44 PST

Next message: Uwe Wagner: "xsane crashes"

Previous message: Henning Meier-Geinitz: "Re: preview and selectable scanarea for MFS-12000's ADF"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Hello

This is a very trivial question, I hope.

I have a Mustek 600 III EP Plus scanner connected to the parallel port.
When I try to run "scanimage -L" I get a message stating that no
scanners were identified and that I should try "find-scanner" tool and
read some documentation. The problem is that I have a parallel port
scanner, but that program and documentation only covers scsi-scanners.

However, the sane documentation states that my scanner is supported.

One problem could be that I have not acquired full understanding in how
the thing about devices works. For instance, how do I set them up?

Any hints? Any pointer to where I can read more? (I have not found so
much information on this matter on the sane homepage.)

Regards,
Daniel

--
Source code, list archive, and docs: http://www.mostang.com/sane/
To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com

Next message: Uwe Wagner: "xsane crashes"
Previous message: Henning Meier-Geinitz: "Re: preview and selectable scanarea for MFS-12000's ADF"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Wed Feb 28 2001 - 13:24:11 PST