Hello,
I have a NEC VERSA 6060 laptop with an Adaptec SlimSCSI 1460 PCMCIA SCSI card.
It works ok with SCSI disc drives, but the scanner is not working. Generic
SCSI support is a module. These commands are typed from root.
I appreciate any suggestions, thanks, -Dave.
This is in dmesg (note that the model is reported as C1100A instead of C5100A;
does the hp backend care about that?):
aha152x: processing commandline: ok
aha152x: BIOS test: passed, detected 1 controller(s)
aha152x0: vital data: PORTBASE=0x340, IRQ=9, SCSI ID=7, reconnect=enabled, parity=enabled,
synchronous=disabled, delay=100, extended translation=disabled
aha152x: trying software interrupt, ok.
scsi0 : Adaptec 152x SCSI driver; $Revision: 1.7 $
scsi : 1 host.
Vendor: HP Model: C1100A Rev: R032
Type: Processor ANSI SCSI revision: 02
Detected scsi generic sga at scsi0, channel 0, id 2, lun 0
# cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 02 Lun: 00
Vendor: HP Model: C1100A Rev: R032
Type: Processor ANSI SCSI revision: 02
# ls -l /dev/scanner
lrwxrwxrwx 1 root root 8 Jan 26 22:23 /dev/scanner -> /dev/sga
# ls -l /dev/sga
crw-rw-rw- 1 root sys 21, 0 May 5 1998 /dev/sga
# find-scanner
find-scanner: found processor "HP C1100A " at device /dev/scanner
find-scanner: found processor "HP C1100A " at device /dev/sg0
find-scanner: found processor "HP C1100A " at device /dev/sga
#scanimage --find-devices
scanimage: no SANE devices found
# scanimage -d hp:/dev/sg0
[sanei_init_debug]: Setting debug level of dll to 128.
[dll] adding backend net
[dll] adding backend abaton
[dll] adding backend agfafocus
[dll] adding backend apple
[dll] adding backend artec
[dll] adding backend canon
[dll] adding backend coolscan
[dll] adding backend dmc
[dll] adding backend epson
[dll] adding backend hp
[dll] adding backend microtek
[dll] adding backend microtek2
[dll] adding backend mustek
[dll] adding backend pint
[dll] adding backend qcam
[dll] adding backend ricoh
[dll] adding backend s9036
[dll] adding backend sharp
[dll] adding backend snapscan
[dll] adding backend tamarack
[dll] adding backend umax
[dll] loading backend hp
[dll] dlopen()ing `/usr/local/lib/sane/libsane-hp.so.1'
[dll] init: initializing backend `hp'
scanimage: open of device hp:/dev/sg0 failed: Error during device I/O
[dll] exiting
[dll] calling backend `hp's exit function
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
This archive was generated by hypermail 2b29 : Thu Jan 27 2000 - 04:35:32 PST