mabus <mabus@nebulanet.net> wrote:
>
> I've gotten the kernel(2.2.13) to see the scsi card(i think):
>
> kernel: aha152x: processing commandline: ok
> kernel: aha152x: BIOS test: passed, detected 1 controller(s)
> kernel: aha152x0: vital data: PORTBASE=0x140, IRQ=10, SCSI ID=7,
> reconnect=enabled, parity=enabled, synchronous=disabled,
> delay=100, extended translation=disabled
> kernel: aha152x: trying software interrupt, ok.
> kernel: scsi0 : Adaptec 152x SCSI driver; $Revision: 1.7 $
> kernel: scsi : 1 host.
> kernel: Vendor: Model: Scanner 600 Rev: 1.90
> kernel: Type: Scanner ANSI SCSI revision: 03
> kernel: scsi : detected total.
>
> I compiled it into the kernel and used lilo.conf options to set the i/o
> and irq
>
>
> In /proc/scsi/aha152x/0 is has:
>
> Adaptec 152x SCSI driver; $Revision: 1.7 $
> ioports 0x0140 to 0x015f
> interrupt 0x0a
> disconnection/reconnection enabled
> parity checking enabled
> synchronous transfers disabled
> 0 commands currently queued
> enabled debugging options: (abort) (reset)
>
> queue status:
> no not yet issued commands
> no current command
> no disconnected commands
>
> waiting: SCSISEQ (); SCSISIG (DATA OUT); INTSTAT (lo); SSTAT (BUSFREE
> PHASECHG ); SSTAT (); SXFRCTL0 (CH1 ); SIGNAL (); SELID (02), SSTAT2
> (SEMPTY ); SFCNT (0); SCSICNT (0), OFFCNT(0), SSTAT4 (); DMACNTRL0 (16BIT
> PIO READ INTEN ); DMASTAT (DFIFOEMP )
>
> enabled interrupts ()
>
>
>
> I had no problems building sane-1.0.1
>
> my dll.conf only has microtek in it
> microtek.conf has /dev/sga and i've tried it with and without noprecal
>
> When I run find-scanner it finds nothing. Scanimage says no SANE devices
> found.
>
> I have no clue what to do now. Any ideas?
>
>
>
> --
> Brian McQuay
> mabus@nebulanet.net
>
>
>
> --
> Source code, list archive, and docs: http://www.mostang.com/sane/
> To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com