I am having a problem with my AT6 scanner. it appears to calibrate but then
hangs my entire system forcing a reboot.
my system info is.
Adaptec 1520 host adapter
kernel version 2.3.2
Here is the output from modprobe aha152x
warp9:~# modprobe aha152x
aha152x: BIOS test: passed, auto configuration: ok, detected 1 controller(s)
aha152x0: vital data: PORTBASE=0x340, IRQ=11, SCSI ID=7, reconnect=enabled,
parity=enabled, synchronous=disabled, delay=100, extended translation=disabled
aha152x: trying software interrupt, ok.
scsi0 : Adaptec 152x SCSI driver; $Revision: 1.7 $
scsi : 1 host.
Vendor: ULTIMA Model: AT6 Rev: 1.01
Type: Scanner ANSI SCSI revision: 02
output from scanimage -L
warp9:~# scanimage -L
Detected scsi generic sga at scsi0, channel 0, id 1, lun 0
device `artec:/dev/sg0' is a ULTIMA AT6 flatbed
Also in /var/log/syslog the line
Jun 14 08:31:29 warp9 kernel: Detected scsi generic sga at scsi0, channel 0, id
1, lun 0
appears and I have my scanner set on lun 1 I assume this might be a problem but
im not sure what to do about it.
Any help whould be much appreciated.
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com