I am having trouble getting SANE to work. The scanner is connected and
can be seen by the card:
# cat /proc/scsi/scsi
Attached devices:
Host: scsi0 Channel: 00 Id: 00 Lun: 00
Vendor: HP Model: HP35480A Rev: 9 09
Type: Sequential-Access ANSI SCSI revision: 02
Host: scsi0 Channel: 00 Id: 04 Lun: 00
Vendor: HP Model: C5110A Rev: 3701
Type: Processor ANSI SCSI revision: 02
And find-scanner tells me it's found a 'processor' at /dev/sgb and
/dev/scanner (which is linked to /dev/sgb obviously)
# find-scanner
find-scanner: found processor "HP C5110A 3701" at device /dev/scanner
find-scanner: found processor "HP C5110A 3701" at device /dev/sgb
But this just sits there - for hours.
# scanimage --find-devices
The config files point at /dev/scanner, and 0.73 was first compiled and
installed from a tarball (same problem) then replaced with the 0.74 RPM.
Hopefully it is something simple. I haven't tried it without the tape
drive connected because even if it does work it will be of no use to me
(as I need the tape more than the scanner).
Any help would be most appreciated.
Sam Johnston
sam@unsw.edu.au
-- Source code, list archive, and docs: http://www.mostang.com/sane/ To unsubscribe: echo unsubscribe sane-devel | mail majordomo@mostang.com